Bearing and Distance ? Well, you might want to be aware of a little inconsistency in the command depending on how you run it. Rick Ellis over at Cadapult Software Solutions (the author of the Civil 3. D book we use here at CAD- 1) pointed this out to me and I thought it would warrant a blog post. Thanks Rick! So, here’s the problem, two lines drawn from the same location using the Bearing and Distance transparent command end up with different bearings depending on how you run the Bearing and Distance command. Different Results, Same Input. So, what did I do differently? Well, the bottom line I drew using the Bearing and Distance command by typing . The top line I drew it using the Bearing and Distance command from the Transparent Commands Toolbar (by default on the right side of your drawing area). This will make more sense if I explain what it is I typed. I start the line command and snap to the center of the circle. I then invoke the Bearing and Distance transparent command using one of the methods listed above (repeat with the other method). I then type “1” for the quadrant, “4. Same input different results. That’s great and all but, which one is wrong? Well, technically, they are both right, they’re just different. Neither is wrong, they’re just different. Here is a video with commentary that I made if you want some additional clarification. Between the Lines Autodesk.How to Type Bearing & Distance Lines in AutoCAD. A survey is a legal document that precisely describes a property or region. So, it is extremely important to create. IMAGINiT Technologies Support Blog. AutoCAD - Inputting Survey Bearings. Even though the distance. Then specify the bearing (3) and distance (4). To Create Lines by Specifying Bearings. Applies to AutoCAD Civil 3D 2016 Applies to AutoCAD Civil 3D 2016.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2016
Categories |